2.SYMPTOM:THEWALKINGBELTDOESNOT
MOVESMOOTHLY
a. If the Walking Belt (45) is ov'ert.ightened,perfor-
mance may be reduced and-.t_ Walking Belt
may be permanently damaged. Turn the speed
control fully counterclockwise. Using the included
42
allen wrench, turn both Rear Roller Adjustment
Bolts (42) counterclockwise 1/4 of a turn. When
the tension of the Walking Belt is correct, you
should be able to lift each side of the walking belt
2 to 3 inches; the center of the Walking Belt
should just touch the surface of the walking plat-
form. Walk on the treadmill for a few minutes.
Repeat until the Walking Belt is propedy tight-
ened. Be careful to keep the Walking Belt can-
tered.
3. SYMPTOM: THE WALKING BELT SLIPS OR IS
OFF-CENTER
a. If the Walking
Belt (45) slips
when walked
on, use the
allen wrench to
turn both Rear
Roller
Adjustment
Belts (42) clockwise, 1/4 of a turn. When the
Walking Belt is correctly tightened, you should be
able to lifteach side of the Walking Belt 2 to 3
inches off the walking platform. The center of the
Walking Belt should just touch the walking plat-
form. Walk on the treadmill for a few minutes.
Repeat until the Walking Belt is properly tightened.
Be careful to keep the Walking Belt centered.
b. If the Walking
Belt (45) has
shifted to the
left side, use
the allen
wrench to turn
the left Rear
Roller Adjustment Bolt (42) clockwise, and the
right Bolt counterclockwise, 1/4 of a turn each. Be
careful not to overtighten the Walking Belt. Walk
on the treadmill for a few minutes. Repeat until
the Walking Belt is centered.
c. If the Walking
Belt (45) has
shifted to the
right side, use
the allen
wrench to turn
the left Rear
Roller
Adjustment Bolt (42) countemlockwise, and the
right Bolt clockwise, 1/4 of a turn each. Be care-
ful not to overtighten the Walking Belt. Walk on
the treadmill for a few minutes.Repeat untilthe
Walking Belt is centered.
4_ SYMPTOM: THE RESISTANCE ON THE WALK-
ING BELT DOES NOT INCREASE WHEN THE
SPEED KNOB IS TURNED
a. If the resistance on the walking belt does not
increase when the speed knob is turned clock-
wise, the resistance belt should be tightened.
To tighten the resistance belt, first tum the speed
control counterclockwise as far as it will tum.
Next, remove the four screws attaching the Hood
(14). Remove the Hood and locate the
Resistance Belt (67) and the Resistance Clamp
(60). Open the Resistance Clamp, pullthe
Resistance Belt slightlytighter, and firmly close
the Resistance Clamp. Turn the speed knob
clockwise and walk on the walking belt to check
for increased tension. Reattach the Hood.
8
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern